Filter
Top Products
10
STP COMMANDS
Use Spanning Tree Protocol (STP) commands to configure and manage
spanning trees on the virtual LANs (VLANs) configured on a wireless LAN
switch or controller, to maintain a loop-free network.
STP Commands by
Usage
This chapter presents STP commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 59 STP Commands by Usage
Type Command
STP State set spantree on page 336
display spantree on page 324
display spantree blockedports on page 327
Bridge Priority set spantree priority on page 344
Port Cost set spantree portcost on page 340
set spantree portvlancost on page 343
display spantree portvlancost on page 329
clear spantree portcost on page 320
clear spantree portvlancost on page 321
Port Priority set spantree portpri on page 342
set spantree portvlanpri on page 344
clear spantree portpri on page 321
clear spantree portvlanpri on page 322
Timers set spantree fwddelay on page 338
set spantree hello on page 338
set spantree maxage on page 339
Fast Convergence set spantree portfast on page 341
display spantree portfast on page 328