Filter
Top Products
434 CHAPTER 15: 802.1X MANAGEMENT COMMANDS
forceunauth — Forces the specified wired authentication port(s) to
unconditionally reject all 802.1X authentication attempts with an EAP
failure message.
auto — Allows the specified wired authentication ports to process
802.1X authentication normally as determined for the user by the set
authentication dot1X command.
port-list — One or more wired authentication ports for which to
set 802.1X port control.
Defaults — By default, wired authentication ports are set to auto.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command affects only wired authentication ports.
Examples — The following command forces port 1 to unconditionally
accept all 802.1X authentication attempts:
WX4400# set dot1x port-control forceauth 1
success: authcontrol for 1 is set to FORCE-AUTH.
See Also
display port status on page 66
display dot1x on page 427
set dot1x
quiet-period
Sets the number of seconds an WX remains quiet and does not respond
to a supplicant after a failed authentication.
Syntax —
set dot1x quiet-period seconds
seconds — Specify a value between 0 and 65,535.
Defaults — The default is 60 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.