Filter
Top Products
278 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
set radio-profile mode on page 291
set {ap | dap} radio
tx-power
Sets an MAP radio’s transmit power.
Syntax —
set {ap port-list | dap dap-num} radio {1 | 2}
tx-power power-level
ap port-list — List of ports connected to the MAP access points on
which to set the transmit power.
dap dap-num — Number of a Distributed MAP on which to set the
transmit power.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
tx-power power-level — Number of decibels in relation to
1 milliwatt (dBm). The valid values depend on the country of
operation.
The maximum transmit power you can configure on any 3Com radio
is the maximum allowed for the country in which you plan to operate
the radio or one of the following values if that value is less than the
country maximum: on an 802.11a radio, 11 dBm for channel numbers
less than or equal to 64, or 10 dBm for channel numbers greater than
64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for
802.11b, or 14 dBm for all valid channel numbers for 802.11g.
Defaults — The default transmit power on all MAP radio types is the
highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You also can configure a radio’s channel on the same
command line. Use the channel option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is
enabled.