Filter
Top Products
234 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
clear {ap | dap}
radio
Disables a MAP radio and resets it to its factory default settings.
Syntax —
clear {ap port-list | dap dap-num } radio {1 | 2 |
all}
ap port-list — List of ports connected to the MAP access point(s) on
which to reset a radio.
dap dap-num — Number of a Distributed MAP on which to reset a
radio.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
radio all — All radios on the MAP.
Defaults — The clear ap radio command resets the radio to the default
settings listed in Table 44 and in Table 57 on page 292.
Access — Enabled
History —Introduced in MSS Version 3.0.
Table 44 Radio-Specific Parameters
Parameter Default Value Description
channel 802.11b — 6
802.11a — Lowest
valid channel number
for the country of
operation
Number of the channel in
which a radio transmits and
receives traffic
tx-power Highest setting allowed for
the country of operation
or highest setting
supported on the
hardware, whichever is
lower.
Transmit power of a radio, in
decibels referred to
1 milliwatt (dBm)
antennatype internal
(The default for model
MP-262 is ANT1060.)
External antenna model
Note: This parameter applies
only to MAPs that support
external antennas.