Filter
Top Products
284 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
set radio-profile
auto-tune
power-backoff-
timer
Sets the interval at which radios in a radio profile reduce power after
temporarily increasing the power to maintain the minimum data rate for
an associated client. At the end of each power-backoff interval, radios
that temporarily increased their power reduce it by 1 dBm. The power
backoff continues in 1 dBm increments after each interval until the power
returns to expected setting.
Syntax —
set radio-profile name auto-tune power-backoff-timer
seconds
name — Radio profile name.
seconds — Number of seconds radios wait before lowering the power
by 1 dBm. You can specify from 0 to 65535 seconds.
Defaults — The default power-backoff interval is 10 seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
A radio can increase power again if required to preserve the minimum
data rate for an associated client.
Examples — The following command changes the power-backoff
interval for radios in radio profile rp2 to 15 seconds:
WX4400# set radio-profile rp2 auto-tune
power-backoff-timer 15
success: change accepted.
See Also
set {ap | dap} radio auto-tune max-power on page 270
set {ap | dap} radio auto-tune max- retransmissions on page 271
set radio-profile auto-tune power-config on page 285
set radio-profile auto-tune power-interval on page 286