Filter
Top Products
set snmp trap receiver 153
History —Introduced in MSS Version 3.0.
Usage — You can enable or disable the linkup and linkdown traps on an
individual port basis with the set port trap command. The individual port
setting overrides the global setting.
Examples — The following command disables all traps:
WX4400# set snmp trap disable all
success: change accepted.
The following command reenables authentication traps:
WX4400# set snmp trap enable AuthenTraps
success: change accepted.
See Also
clear snmp trap receiver on page 114
display snmp configuration on page 128
set ip snmp server on page 142
set snmp community on page 150
set snmp trap receiver on page 153
set snmp trap
receiver
Adds an IP address to the SNMP trap receiver table.
Syntax —
set snmp trap receiver ip-addr
ip-addr — IP address of the trap receiver, in dotted decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — To set the IP address of the SNMP trap receiver to
192.168.0.1, type the following command:
WX4400# set snmp trap receiver 192.168.0.1
success: change accepted.
See Also
clear snmp trap receiver on page 114