Filter
Top Products
set ip ssh 143
History — Introduced in MSS Version 3.0.
Examples — The following command enables the SNMP server on a WX
switch:
WX4400# set ip snmp server enable
success: change accepted.
See Also —
clear snmp trap receiver on page 114
display snmp configuration on page 128
set port trap on page 82
set snmp community on page 150
set snmp trap on page 151
set snmp trap receiver on page 153
set ip ssh Changes the TCP port number on which a wireless LAN switch listens for
Secure Shell (SSH) management traffic.
CAUTION: If you change the SSH port number from an SSH session, MSS
immediately ends the session. To open a new management session, you
must configure the SSH client to use the new TCP port number.
Syntax —
set ip ssh port port-num
port-num — TCP port number.
Defaults — The default SSH port number is 22.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the SSH port number on
a WX switch to 6000:
WX4400# set ip ssh port 6000
success: change accepted.
See Also
set ip ssh absolute-timeout on page 144