Filter
Top Products
482 CHAPTER 18: FILE MANAGEMENT COMMANDS
See Also
display boot on page 477
load config Loads configuration commands from a file and replaces the WX switch’s
running configuration with the commands in the loaded file.
CAUTION: This command completely removes the running configuration
and replaces it with the configuration contained in the file. 3Com
recommends that you save a copy of the current running configuration to
a backup configuration file before loading a new configuration.
Syntax —
load config [url]
url — Filename. Specify between 1 and 128 alphanumeric characters,
with no spaces.
If the file is in a subdirectory, specify the subdirectory name, followed
by a forward slash, in front of the filename. For example:
backup_configs/config_c.
Defaults — The default file location is nonvolatile storage.
The current version supports loading a configuration file only from the
switch’s nonvolatile storage. You cannot load a configuration file directly
from a TFTP server.
If you do not specify a filename, MSS uses the same configuration
filename that was used for the previous configuration load. For example,
if the WX switch used configuration for the most recent configuration
load, MSS uses configuration again unless you specify a different
filename. To display the filename of the configuration file MSS loaded
during the last reboot, use the display boot command.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Serial # MAP serial number.
Versions MAP hardware, firmware, and software versions.
Table 94 Output for display version (continued)
Field Description