Filter
Top Products
19
TRACE COMMANDS
Use trace commands to perform diagnostic routines. While MSS allows
you to run many types of traces, this chapter describes commands for
those traces you are most likely to use. For a complete listing of the types
of traces MSS allows, type the set trace ? command.
CAUTION: Using the set trace command can have adverse effects on
system performance. 3Com recommends that you use the lowest levels
possible for initial trace commands, and slowly increase the levels to get
the data you need.
Commands by
Usage
This chapter presents trace commands alphabetically. Use Table 95 to
locate commands in this chapter based on their use.
clear log trace Deletes the log messages stored in the trace buffer.
Syntax — clear log trace
Defaults — None.
Table 95 Trace Commands by Usage
Type Command
Trace set trace sm on page 497
set trace dot1x on page 496
set trace authentication on page 494
set trace authorization on page 495
display trace on page 493
save trace on page 494
clear trace on page 492
clear log trace on page 491