Filter
Top Products
76 CHAPTER 4: PORT COMMANDS
The following command removes Distributed MAP 1:
WX4400# clear dap 1
This will clear specified DAP devices.
Would you like to continue? (y/n) [n]y
See Also
clear dap on page 58
clear port type on page 61
set port type ap on page 83
set radio-profile 11g-only on page 280
set system countrycode on page 51
set port Administratively disables or reenables a port.
Syntax — set port {enable | disable} port-list
enable — Enables the specified ports.
disable — Disables the specified ports.
port-list — List of physical ports. MSS disables or reenables all the
specified ports.
Defaults — All ports are enabled.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — A port that is administratively disabled cannot send or receive
packets. This command does not affect the link state of the port.
Examples — The following command disables port 6:
WX1200# set port disable 6
success: set "disable" on port 6
The fol1owing command reenables the port:
WX1200# set port enable 6
success: set "enable" on port 6