Filter
Top Products
236 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Defaults — If you reset an individual parameter, the parameter is
returned to the default value listed in Table 57 on page 292.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If you specify a parameter, the setting for the parameter is
reset to its default value. The settings of the other parameters are
unchanged and the radio profile remains in the configuration. If you do
not specify a parameter, the entire radio profile is deleted from the
configuration. All radios that use this profile must be disabled before you
can delete the profile.
Examples — The following commands disable the radios that are using
radio profile rp1 and reset the beaconed-interval parameter to its
default value:
WX4400# set radio-profile rp1 mode disable
WX4400# clear radio-profile rp1 beacon-interval
success: change accepted.
The following commands disable the radios that are using radio profile
rptest and remove the profile:
WX4400# set radio-profile rptest mode disable
WX4400# clear radio-profile rptest
success: change accepted.
See Also
display radio-profile on page 257
set {ap | dap} radio radio-profile on page 277
set radio-profile mode on page 291
clear service-profile Removes a service profile or resets one of the profile’s parameters to its
default value.
Syntax —
clear service-profile name
name — Service profile name.
Defaults — None.