Filter
Top Products
294 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
The following command enables the WPA IE on MAP radios in radio
profile rp2:
WX4400# set radio-profile rp2 wpa-ie enable
success: change accepted.
See Also
display {ap | dap} config on page 237
display radio-profile on page 257
set {ap | dap} radio mode on page 276
set {ap | dap} radio radio-profile on page 277
set radio-profile
preamble-length
Changes the preamble length for which an 802.11b/g MAP radio
advertises support. This command does not apply to 802.11a.
Syntax —
set radio-profile name
preamble-length
{long | short}
name — Radio profile name.
long — Advertises support for long preambles.
short — Advertises support for short preambles.
Defaults — The default is short.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Changing the preamble length value affects only the support
advertised by the radio. Regardless of the preamble length setting (short
or long), an 802.11b/g radio accepts and can generate 802.11b/g frames
with either short or long preambles.
If a client associated with an 802.11b/g radio uses long preambles for
unicast traffic, the MAP access point still accepts frames with short
preambles but does not transmit frames with short preambles. This
change also occurs if the access point overhears a beacon from an
802.11b/g radio on another access point that indicates the radio has
clients that require long preambles.