Filter
Top Products
50 CHAPTER 3: SYSTEM SERVICE COMMANDS
set prompt Changes the CLI prompt for the WX switch to a string you specify.
Syntax —
set prompt string
string — Alphanumeric string up to 32 characters long. To include
spaces in the prompt, you must enclose the string in double quotation
marks (“”).
Defaults — The factory default for the WX switch name is the model
number (WX1200 for the 3Com Wireless LAN Switch WX1200, WX4400
for the 3Com Wireless LAN Controller WX4400).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — When you first log in for the initial configuration of the WX
switch, the CLI provides a WX1200> or WX4400> prompt, depending on
your model. After you become enabled by typing enable and giving a
suitable password, the WX1200# or WX4400# prompt is displayed.
If you use the set system name command to change the default system
name, MSS uses that name in the prompt, unless you also change the
prompt with set prompt.
Examples — The following example sets the prompt from WX4400 to
happy_days:
WX4400# set prompt happy_days
success: change accepted.
happy_days#
See Also
clear prompt on page 39
display config on page 478
set system name on page 55