Filter
Top Products
84 CHAPTER 4: PORT COMMANDS
mp-122 — Contains one 802.11a radio and one 802.11b/g radio.
mp-241 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g.
mp-252 — Contains one 802.11a radio and one 802.11b radio.
mp-262 — Contains one 802.11a radio and one 802.11b radio,
and a connector for an external antenna for the 802.11b/g radio.
mp-341 — Contains one radio that can be configured through
software for 802.11a or 802.11b/g, and a connector for an
external antenna for the 802.11b/g radio.
mp-352 — Contains one 802.11a radio and one 802.11b radio,
and a connector for an external antenna for the 802.11b/g radio.
mp-372 — Contains one 802.11a radio and one 802.11b radio,
and a connector for an external antenna for the 802.11b/g radio.
Also has a connector for an optional 802.11a antenna. To specify
the antenna model, use the following command:
set {ap | dap} radio antennatype.
poe enable | disable — Power over Ethernet (PoE) state.
radiotype 11a | 11b | 11g — Radio type:
11a — 802.11a
11b — 802.11b
11g — 802.11g
This option does not apply to single-radio models. The value 11g does
not apply to model MP-101.
Defaults — All WX ports are network ports by default.
The default radio type for model MP-101 is 802.11b. The default radio
type for model AP2750, AP7250, MP-241, and MP-341, and for the
802.11b/g radios in models AP8250, AP8750, MP-52, MP-252, MP-262,
and MP-352, is 802.11g in regulatory domains that support 802.11g, or
802.11b in regulatory domains that do not support 802.11g.
MAP radios configured for 802.11g also allow associations from 802.11b
clients by default. To disable support for 802.11b associations, use the
set radio-profile 11g-only command on the radio profile that contains
the radio.