Filter
Top Products
set igmp oqi 363
set igmp oqi Changes the IGMP other-querier-present interval timer on one VLAN or
all VLANs on a WX.
Syntax —
set igmp oqi seconds [vlan vlan-id]
oqi seconds — Number of seconds that the WX waits for a general
query to arrive before electing itself the querier. You can specify a
value from 1 through 65,535.
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default other-querier-present interval is 255 seconds
(4.25 minutes).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — A WX cannot become the querier unless the pseudo-querier
feature is enabled on the WX switch. When the feature is enabled, the
WX becomes the querier for a subnet so long as the WX does not receive
a query message from a router with a lower IP address than the IP
address of the WX in that subnet. To enable the pseudo-querier feature,
use set igmp querier.
Examples — The following command changes the other-querier-present
interval on VLAN orange to 200 seconds:
WX1200# set igmp oqi 200 vlan orange
success: change accepted.
See Also
set igmp lmqi on page 360
set igmp qi on page 364
set igmp qri on page 365
set igmp querier on page 366
set igmp mrouter on page 360
set igmp rv on page 368