Filter
Top Products
276 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
set {ap | dap} radio
mode
Enables or disables a radio on an MAP access point.
Syntax —
set {ap port-list | dap dap-num} radio {1 | 2}
mode {enable | disable}
ap port-list — List of ports connected to the MAP access point(s) on
which to turn a radio on or off.
dap dap-num — Number of a Distributed MAP on which to turn a
radio on or off.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
mode enable — Enables a radio.
mode disable — Disables a radio.
Defaults — MAP access point radios are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To enable or disable one or more radios to which a profile is
assigned, use the set ap radio radio-profile command. To enable or
disable all radios that use a specific radio profile, use the set
radio-profile command.
Examples — The following command enables radio 1 on the MAP access
points connected to ports 1 through 5:
WX1200# set ap 1-5 radio 1 mode enable
success: change accepted.
The following command enables radio 2 on ports 1 through 3:
WX1200# set ap 1-3 radio 2 mode enable
success: change accepted.
See Also
clear {ap | dap} radio on page 234
display {ap | dap} config on page 237
set {ap | dap} radio radio-profile on page 277