Filter
Top Products
set radio-profile auto-tune channel-interval 283
set radio-profile
auto-tune
channel-interval
Sets the interval at which RF Auto-Tuning decides whether to change the
channels on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous
interval, and changes radio channels if needed.
Syntax —
set radio-profile name auto-tune channel-interval
seconds
name — Radio profile name.
seconds — Number of seconds RF Auto-Tuning waits before
changing radio channels to adjust to RF changes, if needed. You can
specify from 0 to 65535 seconds.
Defaults — The default channel interval is 3600 seconds (one hour).
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — 3Com recommends that you use an interval of at least 300
seconds (5 minutes).
RF Auto-Tuning can change a radio’s channel before the channel interval
expires in response to RF anomalies. Even in this case, channel changes
cannot occur more frequently than the channel holddown interval.
If you set the interval to 0, RF Auto-Tuning does not reevaluate the
channel at regular intervals. However, RF Auto-Tuning can still change
the channel in response to RF anomalies.
Examples — The following command sets the channel interval for radios
in radio profile rp2 to 2700 seconds (45 minutes):
WX4400# set radio-profile rp2 auto-tune channel-interval 2700
success: change accepted.
See Also
set radio-profile auto-tune channel-config on page 281
set radio-profile auto-tune channel-holddown on page 282