Filter
Top Products
274 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
This command is not valid if dynamic channel tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the channel on the
802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 channel 36
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
“display {ap | dap} config” on page 237
set {ap | dap} radio tx-power on page 278
set {ap | dap} radio
min-client-rate
Sets the minimum rate at which a radio is allowed to transmit traffic to
clients. The radio automatically increases its transmit power when
necessary to maintain at least the minimum rate with an associated client.
Syntax —
set {ap port-list | dap dap-num } radio {1 | 2}
auto-tune min-client-rate rate
ap port-list — List of ports connected to the MAP access points on
which to set the channel.
dap dap-num — Number of a Distributed MAP on which to set the
channel.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
rate — Minimum data rate, in megabits per second (Mbps). The valid
values depend on the radio type:
For 802.11g radios—54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, or 1
For 802.11b radios—11, 5.5, 2, or 1
For 802.11a radios—54, 48, 36, 24, 18, 12, 9, or 6