Filter
Top Products
set dot1x max-req 433
success: dot1x key transmission enabled.
See Also
display dot1x on page 427
set dot1x max-req Sets the maximum number of times the WX retransmits an EAP request
to a supplicant (client) before ending the authentication session.
Syntax —
set dot1x max-req number-of-retransmissions
number-of-retransmissions — Specify a value between 0 and 10.
Defaults — The default number of EAP retransmissions is 2.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — To support SSIDs that have both 802.1X and static WEP clients,
MSS sends a maximum of two ID requests, even if this parameter is set to
a higher value. Setting the parameter to a higher value does affect all
other types of EAP messages.
Examples — Type the following command to set the maximum number
of EAP request retransmissions to three attempts:
WX4400# set dot1x max-req 3
success: dot1x max request set to 3.
See Also
clear dot1x max-req on page 423
display dot1x on page 427
set dot1x
port-control
Determines the 802.1X authentication behavior on individual wired
authentication ports or groups of ports.
Syntax —
set dot1x port-control
{forceauth | forceunauth | auto} port-list
forceauth — Forces the specified wired authentication port(s) to
unconditionally authorize all 802.1X authentication attempts, with an
EAP success message.