Filter
Top Products
282 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
success: change accepted.
See Also
set radio-profile auto-tune channel-holddown on page 282
set radio-profile auto-tune channel-interval on page 283
set radio-profile auto-tune power-config on page 285
set radio-profile
auto-tune
channel-holddown
Sets the minimum number of seconds a radio in a radio profile must
remain at its current channel assignment before RF Auto-Tuning can
change the channel. The channel holddown provides additional stability
to the network by preventing the radio from changing channels too
rapidly in response to spurious RF anomalies such as short-duration
channel interference.
Syntax —
set radio-profile name auto-tune channel-holddown
holddown
name — Radio profile name.
holddown — Minimum number of seconds a radio must remain on its
current channel setting before RF Auto-Tuning is allowed to change
the channel. You can specify from 0 to 65535 seconds.
Defaults — The default RF Auto-Tuning channel holddown is 900
seconds.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The channel holddown applies even if RF anomalies occur that
normally cause an immediate channel change.
Examples — The following command changes the channel holddown
for radios in radio profile rp2 to 600 seconds:
WX4400# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
See Also
set radio-profile auto-tune channel-config on page 281
set radio-profile auto-tune channel-interval on page 283