Filter
Top Products
126 CHAPTER 6: IP SERVICES COMMANDS
display ntp Shows NTP client information.
Syntax —
display ntp
Defaults — None.
Access — All.
History —Introduced in MSS Version 3.0.
Examples — To display NTP information for a WX switch, type the
following command:
WX4400> display ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server Peer state Local State
---------------------------------------------------
192.168.1.5 SYSPEER SYNCED
Table 33 describes the fields in this display.
Table 33 Output for display ntp
Field Description
NTP client State of the NTP client. The state can be one of the
following:
Enabled
Disabled
Current update-interval Number of seconds between queries sent by the WX
switch to the NTP servers for updates.
Current time System time that was current on the WX switch when you
pressed Enter after typing the display ntp command.
Timezone Time zone configured on the WX switch. MSS offsets the
time reported by the NTP server based on the time zone.
This field is displayed only if you change the time zone.