set vlan tunnel-affinity 105
If you do specify a tag value, 3Com recommends that you use the same
value as the VLAN number. MSS does not require the VLAN number and
tag value to be the same but some other switches do.
Examples — The following command assigns the name beige to VLAN
11 and adds ports 1 through 3 to the VLAN:
WX1200# set vlan 11 name beige port 1-3
success: change accepted.
The following command adds port 6 to VLAN beige and assigns tag value
86 to the port:
WX1200# set vlan beige port 6 tag 86
success: change accepted.
See Also
■ “clear vlan” on page 91
■ “display vlan config” on page 99
■ “set vlan name” on page 103
set vlan
tunnel-affinity
Changes a wireless LAN switch’s preferability within a mobility domain for
tunneling user traffic for a VLAN. When a user roams to a WX switch that
is not a member of the user’s VLAN, the WX can forward the user traffic
by tunneling to another WX switch that is a member of the VLAN.
Syntax —
set vlan vlan-id tunnel-affinity num
■ vlan-id — VLAN name or number.
■ num — Preference of this switch for forwarding user traffic for the
VLAN. You can specify a value from 1 through 10. A higher number
indicates a greater preference.
Default — Each VLAN on a WX switch’s network ports has an affinity
value of 5 by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Increasing a WX switch’s affinity value increases the WX’s
preferability for forwarding user traffic for the VLAN.
