Filter
Top Products
set {ap | dap} upgrade-firmware 279
Examples — The following command configures the transmit power on
the 802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
“display {ap | dap} config” on page 237
set {ap | dap} radio channel on page 273
set {ap | dap}
upgrade-firmware
Disables or reenables automatic upgrade of an MAP access point’s boot
firmware.
Syntax —
set {ap port-list | dap dap-num}
upgrade-firmware {enable | disable}
ap port-list — List of ports connected to the MAP access point(s) on
which to allow automatic firmware upgrades.
dap dap-num — Number of a Distributed MAP on which to allow
automatic firmware upgrades.
enable — Enables automatic firmware upgrades.
disable — Disables automatic firmware upgrades.
Defaults — Automatic firmware upgrades of MAP access points are
enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — When the feature is enabled on an WX port, an MAP access
point connected to that port upgrades its boot firmware to the latest
version stored on the WX switch while booting.