Filter
Top Products
124 CHAPTER 6: IP SERVICES COMMANDS
See Also
clear ip route on page 111
display interface on page 118
display vlan config on page 100
set interface on page 135
set ip route on page 140
Table 31 Output of display ip route
Field Description
Destination/Mask IP address and subnet mask of the route destination.
The 244.0.0.0 route is automatically added by MSS and
supports the IGMP snooping feature.
Proto Protocol that added the route to the IP route table. The protocol
can be one of the following:
IP — MSS added the route.
Static — An administrator added the route.
Metric Cost for using the route.
NH-Type Next-hop type:
Local — Route is for a local interface. MSS adds the route
when you configure an IP address on the WX switch.
Direct — Route is for a locally attached subnet. MSS adds
the route when you add an interface in the same subnet to
the WX switch.
Router — Route is for a remote destination. A WX switch
forwards traffic for the destination to the gateway router.
Gateway Next-hop router for reaching the route destination.
This field applies only to static routes.
VLAN:Interface Destination VLAN, protocol type, and IP address of the route.
Because direct routes are for local interfaces, a destination IP
address is not listed.
The destination for the IP multicast route is MULTICAST.
For static routes, the value Down means the WX switch does not
have an interface to the destination’s next-hop router. To
provide an interface, configure an IP interface that is in the same
IP subnet as the next-hop router. The IP interface must be on a
VLAN containing the port that is attached to the gateway
router.