Filter
Top Products
set port speed 81
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400.
If you set the preference to RJ-45 (copper) on a port that already has an
active fiber link, MSS immediately changes the link to the copper
interface.
Examples — The following command sets the preference of port 2 on a
WX4400 to RJ-45 (copper):
WX4400# set port preference 2 rj45
See Also
clear port preference on page 60
display port preference on page 65
set port speed Changes the speed of a port.
Syntax — set port speed port-list {10 | 100 | 1000 | auto}
port-list — List of physical ports. MSS sets the port speed on all the
specified ports.
10 — Sets the port speed of a 10/100 Ethernet port to 10 Mbps and
sets the operating mode to full-duplex.
100 — Sets the port speed of a 10/100 Ethernet port to 100 Mbps
and sets the operating mode to full-duplex.
1000 — Sets the port speed of a gigabit Ethernet port to 1000 Mbps
and sets the operating mode to full-duplex.
auto — Enables a port to detect the speed and operating mode of the
traffic on the link and set itself accordingly.
Defaults — All ports are set to auto.
Access — Enabled.
History — Introduced in MSS Version 3.0.