Filter
Top Products
364 CHAPTER 11: IGMP SNOOPING COMMANDS
set igmp
proxy-report
Disables or reenables proxy reporting by a WX on one VLAN or all VLANs.
Syntax —
set igmp proxy-report {enable | disable}
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, proxy reporting is disabled or reenabled on all VLANs.
enable — Enables proxy reporting.
disable — Disables proxy reporting.
Defaults — Proxy reporting is enabled on all VLANs by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Proxy reporting reduces multicast overhead by sending only
one membership report for a group to the multicast routers and
discarding other membership reports for the same group. If you disable
proxy reporting, the WX sends all membership reports to the routers,
including multiple reports for the same group.
Examples — The following example disables proxy reporting on VLAN
orange:
WX1200# set igmp proxy-report disable vlan orange
success: change accepted.
See Also
set igmp rv on page 368
set igmp qi Changes the IGMP query interval timer on one VLAN or all VLANs on a
WX.
Syntax —
set igmp qi seconds [vlan vlan-id]
qi seconds — Number of seconds that elapse between general
queries sent by the WX when the WX switch is the querier for the
subnet. You can specify a value from 1 through 65,535.
vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default query interval is 125 seconds.