Filter
Top Products
114 CHAPTER 6: IP SERVICES COMMANDS
Examples — To reset the NTP interval to the default value, type the
following command:
WX4400# clear ntp update-interval
success: change accepted.
See Also
clear ntp server on page 113
display ntp on page 126
set ntp on page 148
set ntp server on page 148
set ntp update-interval on page 149
clear snmp trap
receiver
Clears a single entry from the Simple Network Management Protocol
(SNMP) trap receiver table.
Syntax —
clear snmp trap receiver ip-addr
ip-addr — IP address of the trap receiver, in dotted decimal notation.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To delete the trap receiver at IP address 192.168.0.1, type
the following command:
WX4400# clear snmp trap receiver 192.168.0.1
success: change accepted.
See Also
set ip snmp server on page 142
set snmp community on page 150
set snmp trap on page 151
set snmp trap receiver on page 153