Filter
Top Products
240 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
See Also
display dap connection on page 253
display dap global on page 254
display dap unconfigured on page 256
display radio-profile on page 257
set dap on page 73
set port type ap on page 83
set {ap | dap} bias on page 264
set {ap | dap} group on page 267
set {ap | dap} name on page 268
set {ap | dap} upgrade-firmware on page 279
set {ap | dap} radio mode on page 276
set {ap | dap} radio antennatype on page 269
set {ap | dap} radio channel on page 273
set {ap | dap} radio radio-profile on page 277
set {ap | dap} radio tx-power on page 278
auto-tune
min-client-rate
Minimum data rate the radio must maintain for associated
clients. When RF Auto-Tuning is enabled, the radio can
temporarily increase its power to maintain the data rate with
an associated client.
auto-tune
max-retransmissions
Maximum percentage of packets that can be retransmitted
by a client before RF Auto-Tuning increases power.
Note: Only packets that are received twice by the MAP are
counted as retransmissions. If a client retransmits a packet
but the MAP receives only a single copy of the packet, the
packet is not counted as a retransmission.
Table 45 Output for display ap config (continued)
Field Description