Filter
Top Products
display tunnel 99
display tunnel Shows the tunnels from the wireless LAN switch where you type the
command.
Syntax —
display tunnel
Defaults — None.
Access — Enabled
History —Introduced in MSS Version 3.0.
Examples — To display all tunnels from a WX switch to other WX
switches in the Mobility Domain, type the following command.
WX4400# display tunnel
VLAN Local Address Remote Address State Port LVID RVID
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng 192.168.14.2 192.168.14.4 DORMANT 1024 4096 130
Table 23 describes the fields in the display.
See Also
display vlan config on page 100
Table 23 Output for display tunnel
Field Description
VLAN VLAN name.
Local Address IP address of the local end of the tunnel. This is the system
IP address of the wireless access switch where you enter
the command.
Remote Address IP address of the remote end of the tunnel. This is the
system IP address of another WX switch in the mobility
domain.
State Tunnel state:
Up
Dormant
Port Tunnel port ID.
LVID Local VLAN ID.
RVID Remote VLAN ID.