Filter
Top Products
9
MANAGED ACCESS POINT
COMMANDS
Use MAP access point commands to configure and manage MAP access
points. Be sure to do the following before using the commands:
Define the country-specific IEEE 802.11 regulations on the WX switch.
(See set system countrycode on page 51.)
Install the MAP access point and connect it to a port on the WX
switch.
Configure a MAP access port (for a directly connected MAP) or a
Distributed MAP. (See set port type ap on page 83 and set dap on
page 73.)
CAUTION: Changing the system country code after MAP configuration
disables MAP access points and deletes their configuration. If you change
the country code on a WX switch, you must reconfigure all MAP access
points.
MAP Access Point
Commands by
Usage
This chapter presents MAP access point commands alphabetically. Use
Table 43 to locate commands in this chapter based on their use.
Table 43 Map Access Point Commands by Usage
Type Command
External Antenna set {ap | dap} radio antennatype on page 269
Radio Profile
Assignment
set {ap | dap} radio radio-profile on page 277
set radio-profile mode on page 291
clear radio-profile on page 235
set radio-profile service-profile on page 296
display radio-profile on page 257
SSID Assignment set service-profile ssid-name on page 311