506 CHAPTER 21: BOOT PROMPT COMMANDS
Defaults — The diagnostic mode is disabled by default.
Access — Boot prompt.
History — Introduced in MSS Version 3.0.
Usage — Access to the diagnostic mode requires a password, which is
not user configurable. Use this mode only if advised to do so by 3Com.
dir Displays the boot code and system image files on a WX switch.
Syntax — dir [c: | d: | e: | f: | boot0 | boot1]
■ c: — Nonvolatile storage area containing boot partition 0 (primary).
■ d: — Nonvolatile storage area containing boot partition 1 (secondary).
■ e: — Primary partition of the flash card in the flash card slot.
■ f: — Secondary partition of the flash card in the flash card slot.
■ boot0 — Boot partition 0.
■ boot1 — Boot partition 1.
Defaults — None.
Access — Boot prompt.
History — Introduced in MSS Version 3.0.
Usage — To display the system image software versions, use the fver
command. This command does not list the boot code versions. To display
the boot code versions, use the version command.
Examples — The following command displays all the boot code and
system image files on a WX switch:
boot> dir
Internal Compact Flash Directory (Primary):
WXA30001.Rel 8863722 bytes
Internal Compact Flash Directory (Secondary):
WXA30001.Rel 8862885 bytes
