340 CHAPTER 10: STP COMMANDS
Defaults — The default STP priority for all network ports is 128.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command sets the priority of ports 3 and 4 to
48 on VLAN mauve:
WX1200# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.
See Also
■ “clear spantree portpri” on page 317
■ “clear spantree portvlanpri” on page 318
■ “display spantree” on page 320
■ “set spantree portpri” on page 337
set spantree
priority
Changes the STP root bridge priority of a wireless LAN switch on one or
all of its VLANs.
Syntax —
set spantree priority value {all | vlan vlan-id}
■ priority value — Priority value. You can specify a value from 0
through 65,535. The bridge with the lowest priority value is elected to
be the root bridge for the spanning tree.
■ all — Changes the bridge priority on all VLANs.
■ vlan vlan-id — VLAN name or number. MSS changes the bridge
priority on only the specified VLAN.
Defaults — The default root bridge priority for the switch on all VLANs is
32,768.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command sets the bridge priority of VLAN
pink to 69:
WX4400# set spantree priority 69 vlan pink
success: change accepted.
