Filter
Top Products
display auto-tune attributes 249
display auto-tune
attributes
Displays the current values of the RF attributes RF Auto-Tuning uses to
decide whether to change channel or power settings.
Syntax —
display auto-tune attributes
[ap map-num [radio {1 | 2 | all}]]
Syntax — display auto-tune attributes
[dap dap-num [radio {1 | 2 | all}]]
map-num — MAP port connected to the MAP access point for which to
display RF attributes.
dap-num — Number of a Distributed MAP for which to display RF
attributes.
CPU info Specifications and identification of the CPU.
For MAP models MP-352, MP-341, and MP-52, the ID
portion of this field is not applicable.
Uptime Amount of time since the MAP last rebooted using this link.
Note: This field is displayed only when this link is the MAP
access point’s primary link.
Radio 1 type
Radio 2 type
802.11 type and configuration state of the radio.
The configure succeed state indicates that the MAP has
received configuration parameters for the radio and the
radio is ready to accept client connections.
For 802.11b/g radios, 802.11b protect indicates that the
radio is in 802.11b protection mode and is therefore
operating only at 802.11b rates.
Sweep Mode indicates that a disabled radio is
nonetheless participating in rogue detection scans. Even
though this message appears only for disabled radios, all
radios, enabled or disabled, participate in rogue
detection.
Countermeasures Enabled indicates that the radio is
sending countermeasures packets to combat a rogue.
operational channel The channel on which the radio is currently operating.
operational power The power level at which the radio is currently operating.
base mac Base MAC address of the radio.
bssid, ssid SSIDs configured on the radio and their BSSIDs.
Table 49 Output for display ap status (continued)
Field Description