Filter
Top Products
78 CHAPTER 4: PORT COMMANDS
The following commands disable the link for port group server1, change
the list of ports in the group, and reenable the link:
WX1200# set port-group name server1 1-5 mode off
success: change accepted.
WX1200# set port-group name server1 1-4,7 mode on
success: change accepted.
See Also
clear port-group on page 59
display port-group on page 63
set port name Assigns a name to a port. After naming a port, you can use the port
name or number in other CLI commands.
Syntax —
set port port name name
port — Number of a physical port. You can specify only one port.
name name — Alphanumeric string of up to 16 characters, with no
spaces.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To simplify configuration and avoid confusion between a port’s
number and its name, 3Com recommends that you do not use numbers
as port names.
Examples — The following command sets the name of port 7 to
adminpool:
WX1200# set port 7 name adminpool
success: change accepted.
See Also
clear port name on page 59
display port status on page 66