Filter
Top Products
set {ap | dap} group 267
Examples — The following command enables LED blink mode on the
MAP access points connected to ports 3 and 4:
WX1200# set ap 3-4 blink enable
success: change accepted.
set {ap | dap} group Configures a named group of MAP access points. MSS automatically load
balances sessions among the access points in a group. To balance the
sessions, MSS rejects an association request for an access point’s radio if
that radio has at least four more active sessions than the radio of the
same type with the least number of active sessions within the group.
Syntax —
set {ap port-list | dap dap-num} group name
ap port-list — List of MAP access ports to add to the group.
dap dap-num — Number of a Distributed MAP to add to the group.
name — MAP access point group name of up to 16 alphanumeric
characters, with no spaces.
Defaults — MAP access points are not grouped by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can assign any subset or all of the MAP access points
connected to an WX switch to a group on that switch. All access points in
a group must be connected to the same WX switch.
If you use the name none, spelled in any combination of capital or
lowercase letters, the specified MAP access point is cleared from all MAP
access point groups.
Examples — The following command configures an MAP access point
group named loadbalance1 that contains the MAP access points on ports
1, 3, and 5:
WX1200# set ap 1,3,5 group loadbalance1
success: change accepted.