clear prompt 39
Examples — To clear the history buffer, type the following command:
WX4400# clear history
success: command buffer was flushed.
See Also
■ “history” on page 46
clear prompt Resets the system prompt to its previously configured value. If the prompt
was not configured previously, this command resets the prompt to its
default.
Syntax —
clear prompt
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — To reset the prompt, type the following command:
wildebeest# clear prompt
success: change accepted.
WX4400#
See Also
■ “set prompt” on page 50. (For information about default prompts,
see “Command Prompts” on page 22.)
clear system Clears the system configuration of the specified information.
CAUTION: If you change the IP address, any currently configured
Mobility Domain operations cease. You must reset the Mobility Domain.
Syntax —
clear system [contact | countrycode | ip-address |
location | name]
■ contact — Resets the name of contact person for the WX switch to
null.
■ countrycode — Resets the country code for the WX switch to null.
■ ip-address — Resets the IP address of the WX switch to null.
