Filter
Top Products
set {ap | dap} radio channel 273
Examples — The following command changes the max-retransmissions
value to 20:
WX1200# set ap 6 radio 1 auto-tune max-retransmissions 20
success: change accepted.
See Also
set {ap | dap} radio auto-tune max-power on page 270
set radio-profile auto-tune power-backoff- timer on page 284
set radio-profile auto-tune power-config on page 285
set radio-profile auto-tune power-interval on page 286
set {ap | dap} radio
channel
Sets an MAP radio’s channel.
Syntax — set {ap port-list | dap dap-num} radio {1 | 2}
channel channel-number
ap port-list — List of ports connected to the MAP access points on
which to set the channel.
dap dap-num — Number of a Distributed MAP on which to set the
channel.
radio 1 — Radio 1 of the MAP.
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
channel channel-number — Channel number. The valid channel
numbers depend on the country of operation.
Defaults — The default channel depends on the radio type:
The default channel number for 802.11b/g is 6.
The default channel number for 802.11a is the lowest valid channel
number for the country of operation.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can configure a radio’s transmit power on the same
command line. Use the tx-power option.