Filter
Top Products
display rfdetect data 459
See Also
clear rfdetect countermeasures mac on page 456
set rf detect countermeasures on page 465
set rfdetect countermeasures mac on page 466
display rfdetect
data
Displays all the BSSIDs detected by an individual WX switch during an RF
detection scan. The data includes BSSIDs transmitted by other 3Com
radios as well as by third-party access points.
Syntax —
display rfdetect data
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You can enter this command on any WX switch in the Mobility
Domain. The output applies only to the switch on which you enter the
command. To display all devices that a specific 3Com radio has detected,
even if the radio is managed by another WX switch, use the display
rfdetect visible command.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.
Table 86 display rfdetect countermeasures Output
Field Description
Rogue MAC BSSID of the rogue.
Countermeasures
Radio MAC
MAC address of the 3Com radio sending countermeasures
against the rogue.
If the field value is Not Started, MSS has not started
countermeasures against the rogue yet.
WX-IPaddr System IP address of the WX switch that is managing the
MAP that is sending or will send countermeasures.
Port/Radio/Channel Port number, radio number, and channel number of the
countermeasures radio. For a Distributed MAP, the
connection number is labeled dap. (This stands for
distributed ap.)