Filter
Top Products
146 CHAPTER 6: IP SERVICES COMMANDS
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must generate an SSH authentication key to use SSH.
The maximum number of SSH sessions supported on a WX switch is
eight. If Telnet is also enabled, the WX switch can have up to eight Telnet
or SSH sessions, in any combination, and one Console session.
See Also
crypto generate key on page 397
set ip ssh on page 143
set ip ssh absolute-timeout on page 144
set ip ssh idle-timeout on page 145
set ip telnet Changes the TCP port number on which a wireless LAN switch listens for
Telnet management traffic.
CAUTION: f you change the Telnet port number from a Telnet session,
MSS immediately ends the session. To open a new management session,
you must Telnet to the WX switch with the new Telnet port number.
Syntax —
set ip telnet port-num
port-num — TCP port number.
Defaults — The default Telnet port number is 23.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command changes the Telnet port number
on a WX switch to 5000:
WX4400# set ip telnet 5000
success: change accepted.
See Also
clear ip telnet on page 112