122 CHAPTER 6: IP SERVICES COMMANDS
Examples — The following command shows the status and port number
for the HTTPS management interface to the WX switch:
WX4400# display ip https
HTTPS is enabled
HTTPS is set to use port 443
Last 10 Connections:
IP Address Last Connected Time Ago (s)
------------ ----------------------- ------------
10.10.10.56 2003/05/09 15:51:26 pst 349
Table 30 describes the fields in this display.
See Also
■ “clear ip telnet” on page 112
■ “display ip telnet” on page 125
■ “set ip https server” on page 139
■ “set ip telnet” on page 146
■ “set ip telnet server” on page 146
Table 30 Output for display ip https
Field Description
HTTPS is
enabled/disabled
State of the HTTPS server:
■ Enabled
■ Disabled
HTTPS is set to use port TCP port number on which the WX switch listens for
HTTPS connections.
Last 10 connections List of the last 10 devices to establish connections to
the WX switch’s HTTPS server.
IP Address IP address of the device that established the
connection.
If a browser connects to a WX switch from behind a
proxy, then only the proxy IP address is shown. If
multiple browsers connect using the same proxy, the
proxy address appears only once in the output.
Last Connected Time when the WX switch established the HTTPS
connection to the WX switch.
Time Ago (s) Number of seconds since the device established the
HTTPS connection to the WX switch.
