Filter
Top Products
display dap connection 253
set radio-profile auto-tune channel-interval on page 283
set radio-profile auto-tune power-backoff- timer on page 284
set radio-profile auto-tune power-config on page 285
set radio-profile auto-tune power-interval on page 286
display dap
connection
Displays the system IP address of the WX switch that has the active data
connection for a Distributed MAP.
Syntax —
display dap connection
[dap-num | serial-id serial-ID]
dap-num — Number of a Distributed MAP for which to display
information about its active connection.
serial-id serial-ID — MAP access point serial ID.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The serial-id parameter displays the active connection for the
specified Distributed MAP even if that MAP is not configured on this WX
switch. If you instead use the command with the dap-num parameter or
without a parameter, connection information is displayed only for
Distributed MAPs that are configured on this WX switch.
If a Distributed MAP is configured on this WX switch (or another WX
switch in the same Mobility Domain) but does not have an active
connection, the command does not display information for the MAP. To
show configured Distributed MAPs regardless of connection status, use
the display dap global command.
Examples — The following command displays information for all
Distributed MAPs configured on this WX switch that have active
connections:
WX1200# display dap connection
Total number of entries: 2
DAP Serial Id DAP IP Address WX IP Address
--- ----------- --------------- ---------------
2 M9DE48B012F00 10.10.2.27 10.3.8.111