Filter
Top Products
15
802.1X MANAGEMENT
COMMANDS
Use 802. IEEE X management commands to modify the default settings
for IEEE 802.1X sessions on an WX switch. For best results, change the
settings only if you are aware of a problem with the WX switch’s 802.1X
performance.
CAUTION: 802.1X parameter settings are global for all SSIDs configured
on the switch.
Commands by
Usage
This chapter presents 802.1X commands alphabetically. Use Table 77 to
locate commands in this chapter based on their use. For information
about configuring 802.1X commands for user authentication, see “AAA
Commands” on page 163.
Table 77 802.1X Commands by Usage
Type Command
Wired Authentication Port
Control
set dot1x port-control on page 433
clear dot1x port-control on page 423
set dot1x authcontrol on page 430
Keys set dot1x key-tx on page 432
set dot1x tx-period on page 438
clear dot1x tx-period on page 427
set dot1x wep-rekey on page 439
set dot1x wep-rekey-period on page 439
Bonded Authentication clear dot1x bonded-period on page 422
set dot1x bonded-period on page 431
Reauthentication set dot1x reauth on page 435
set dot1x reauth-max on page 436