Filter
Top Products
248 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
Table 49 describes the fields in this display.
Table 49 Output for display ap status
Field Description
DAP Connection ID for the Distributed MAP.
Note: This field is applicable only if the MAP is configured on
the WX switch as a Distributed MAP.
Port WX port number.
Note: This field is applicable only if the MAP is directly
connected to the WX switch and the WX switch’s port is
configured as an MAP access port.
IP-addr IP address of the MAP. The address is assigned to the MAP
by a DHCP server.
Note: This field is applicable only if the MAP is configured on
the WX switch as a Distributed MAP.
AP model MAP access point model number.
manufacturer Company that made the MAP access point.
name MAP access point name.
Link Status of this link with the MAP access point and the MAP
port at the other end of the link. The status can be up or
down.
MAP port MAP port number connected to this WX port.
State State of the MAP:
init — The MAP has been recognized by the WX but has
not yet begun booting.
booting — The MAP has asked the WX for a boot
image.
image downloading — The MAP is receiving a boot
image from the WX.
image downloaded — The MAP has received a boot
image from the WX and is booting.
configuring — The MAP has booted and is ready to
receive or is already receiving configuration parameters
from the WX.
operational — The MAP has received configuration
parameters for one or more radios and is ready to accept
client connections.
configure failure — One or more of the radio
parameters received from the WX is invalid.