Filter
Top Products
set spantree uplinkfast 345
all — Changes the bridge priority on all VLANs.
vlan vlan-id — VLAN name or number. MSS changes the bridge
priority on only the specified VLAN.
Defaults — The default root bridge priority for the switch on all VLANs is
32,768.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command sets the bridge priority of VLAN
pink to 69:
WX4400# set spantree priority 69 vlan pink
success: change accepted.
See Also
display spantree on page 324
set spantree
uplinkfast
Enables or disables STP uplink fast convergence on a wireless LAN switch.
This feature enables a WX switch with redundant links to the network
backbone to immediately switch to the backup link to the root bridge if
the primary link fails.
Syntax — set spantree uplinkfast {enable | disable}
enable — Enables uplink fast convergence.
disable — Disables uplink fast convergence.
Defaults — Disabled.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The uplink fast convergence feature is applicable to bridges
that are acting as access switches to the network core (distribution layer)
but are not in the core themselves. Do not enable the feature on WX
switches that are in the network core.