Filter
Top Products
246 CHAPTER 9: MANAGED ACCESS POINT COMMANDS
See Also
“set {ap | dap} group” on page 267
display {ap | dap}
status
Displays MAP access point and radio status information.
Syntax — display ap status [port-list | all [radio {1 | 2}]]
Syntax — display dap status [dap-num [radio {1 | 2}]]
port-list — List of ports connected to the MAP access point(s) for
which to display status.
dap-num — Number of a Distributed MAP for which to display status.
all — Shows status information for all directly attached MAP access
points and all Distributed MAP access points configured on the switch.
radio 1 — Shows status information for radio 1.
radio 2 — Shows status information for radio 2. (This option does
not apply to single-radio models.)
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. True base MAC addresses of
radios are displayed in MSS Version 3.2. Previously, the base MAC
address displayed for a radio was the true base MAC address plus 2. Note
that a radio’s base MAC address is also used as the BSSID of the first SSID
configured on the radio.
Status Association status of the MAP access point:
Accepting — The MAP access point is accepting new
associations.
Refusing — The MAP access point is refusing new
associations.
Refused Number of association requests refused by the MAP access
point due to load balancing. MSS resets this counter to 0
when the WX switch is restarted, MSS is reloaded, or the
access point is removed from the group.
Table 48 Output for display ap group (continued)
Field Description