Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 982 NDA-24297, Issue 1
M-43 Multiple Console Operation - CCIS
Interactions (cont’d)
4. ATTENDANT CONSOLEs [A-3] may not dial another console directly. Talk path will occur only during
INTERPOSITION TRANSFER [I-5].
5. When more than one ATTENDANT CONSOLE [A-3] is installed, a Primary ATTENDANT CONSOLE
[A-3] may be assigned (AMAT command). This ATTENDANT CONSOLE [A-3] will control the
implementation of DAY/NIGHT CLASS OF SERVICE [D-15].
Programming
STEP 1: ASYD - SYS1, Index 9, Assign the number of ATTENDANT CONSOLE [A-3] in system.
SYS2, Index 2, bit 2, Is this Primary ATTCON system? 0/1: No/Yes. (When Primary goes into Night,
tenant goes into Night.)
SYS2, Index 2, bit 3, Is this normal ATTCON system? 0/1: No/Yes. (When all ATTENDANT
CONSOLES [A-3] go into Night, tenant goes into Night.)
STEP 2: ATRK - To assign the ATTENDANT CONSOLE [A-3]: LEN # = LP, and UNIT. The Line Group is
always 20 and the Level is either 0 or 1. Assign as Route 901. Also assign a Service Feature Class
(SFC 0) and a Route Restriction Class (RSC 0) to the ATTENDANT CONSOLE [A-3].
STEP 3: ASAT - Assign a specific Attendant Number to the ATTENDANT CONSOLE [A-3]. See
INDIVIDUAL ATTENDANT ACCESS [I-6].
STEP 4: AMAT - Assign one of the ATTENDANT CONSOLES [A-3] to serve as the Primary ATTENDANT
CONSOLE [A-3]. This service is assigned on a tenant basis. The ATT Number will correspond to the
Trunk number of that specific console.
STEP 5: MBTK - Make Idle the ATTENDANT CONSOLE [A-3] trunk.
STEP 6: ATNR - Allow tenant-to-tenant connection for Inter and Intra-tenant basis. Assign Tenant Restriction
Index (TRI) 1 for station to station calling; TRI 1 for CALL FORWARDING, TRI 3 for CALL
FORWARDING set by the ATTENDANT CONSOLE [A-3]; TRI 4 for incoming calls to the
ATTENDANT CONSOLE [A-3].