NEC 2400 PX Webcam User Manual


  Open as PDF
of 1089
 
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 17
Automatic Recall - D
term
A-8D
A-8D Automatic Recall - D
term
General Description
This feature works as a timed reminder. When a D
term
handled call remains on hold (EXCLUSIVE HOLD [E-4D]
or NON-EXCLUSIVE HOLD [N-7D]) or during an unattended transfer for a variable, programmable period of
time, the D
term
is automatically alerted.
Operating Procedure
No manual operation is required.
Service Conditions
1. AUTOMATIC RECALL - D
term
timing is default in system data at 30 seconds. See VARIABLE TIMING
PARAMETERS [V-1] for other selectable timing choices.
2. If the D
term
reenters a held or transferred call, timing is reset when the call is returned to a RECALL
position.
3. When a held call returns to the D
term
, a continuous ring of 0.5 seconds ON, 0.5 seconds OFF, and an LED
flashing at 240 IPM occurs until the call is retrieved. The upper LCD goes blank during recall. The signal
occurs whether the D
term
is on-hook or off-hook.
4. When an unattended transfer returns to the originator of the transfer, the D
term
will ring normally for 30
seconds (VARIABLE TIMING PARAMETERS [V-1]), if the release signal is not provided from the
distant end. The LCD displays:
Transferred Transferring
Station Station/Trunk
Note: When the telephone number of the transferred/transferring station exceeds 8 digits, the last 8 digits are
displayed. However, a maximum of 16 digits transferring telephone number can be displayed on the middle
line of LCD depending on the system data.
5. When a D
term
holds a call by NON-EXCLUSIVE HOLD [N-7D] during a THREE-WAY CALL [T-2D],
the AUTOMATIC RECALL - D
term
feature cannot be activated.
Programming
ASYD - System Data 1, Index 144. Recall timing of calls placed on EXCLUSIVE HOLD [E-4D] and
NON-EXCLUSIVE HOLD [N-7D]. For normal operation of 30 seconds, leave as data 00H. (RAM
data is 3FH)
System Data 1, Index 140. Recall timing of station transfers.
System Data 2, Index 12, Bit 0 - Ringer for NON-EXCLUSIVE, Bit 1 - Ringer for EXCLUSIVE
0 = Required
1 = Not Required
RECALL XXXX
XXXX
(Time Display)