Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 657
Station Hunting - Circular S-7
Programming (cont’d)
STEP 2: APHN - Assign Phantom Number (PHSTN) to each Circular Hunt Station (as necessary)
TN: Tenant Number
REAL STN: Station Number of the Circular Hunt station
PH: Phantom Number mode
0 = Used individually
1 = Used as the pilot number (for station hunting)
CNT (PHSTN): Phantom Station Number
Note: * Indicates the order of a station in the group.
For Pilot Stations within a Hunt Group to deny hunting function for incoming call from a station
STEP 1: ASYD - System Data 1, Index 439, Bit 7.
0/1=Incoming call from station is hunted/not hunted.
STEP 2: ASFC - Allow the service feature restriction class (SFI 181) for pilot station which denies hunting
function for a incoming call from station.
When activating the Feature via LDM
STEP 1: ASHCL - Assign each Circular Hunt Group by using the Telephone Numbers.
UGN: User Group Number
TELN: Telephone Numbers of member stations
SECRETARY TELN: Telephone Number of a Secretary Station (If necessary)
STEP 2: ASYD - Assign System Data 1, Index 69, b5 (Resultant hunt when the forwarded party is also busy
after CALL FORWARDING - Busy Line [C-2]).
0 = Hunt in the forwarding party group
1 = Hunt in the forwarded party group
STEP 3: APHNL - Assign Phantom Telephone Number (PHTELN) to each Circular Hunt Group.
UGN: User Group Number
TELN: Telephone Number of the Circular Hunt station
PH: Phantom Number mode
0 = Used Individually
1 = Used as the pilot number (for station hunting)
PHTELN: Phantom Telephone Number
Note
Note:
Multiple PHTELNs (maximum of 16) can be assigned per TELN. Select whether to use each PHTELN for
station hunt or not by the “PH” parameter.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note 1
STEP 1: ASYDN - This data must be assigned to the NCN.
System Data 1, Index 69, b5: Hunting Group when transferred party is busy (Station Hunting after Call
Forwarding - Busy Line):
0 = Hunt in Transferring Party’s Group
1 = Hunt in Transferred Party’s Group