Filter
Top Products
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 497
Multiple Call Forwarding - Busy Line M-24
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
STEP 1: ASYDN - These data must be set to the NCN.
System Data 1, Index 69, b7. Enable Multiple Call Forwarding-Busy Line/Don’t Answer/All Calls. 0/
1=Out of Service/In Service. Index 5, b1-b3. Assign the number of time for forwarding.
Note: When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.