Filter
Top Products
NEAX2400 IPX Feature Programming Manual
Page 568 NDA-24297, Issue 1
O-13 Overflow - UCD
Programming (cont’d)
STEP 2: ANPD - Reserve a number level for feature access. Assign for Normal (N), Hooking (H), and Busy
(B) (if applicable to any feature in this level). Assign NND in accordance with a predetermined
numbering plan.
STEP 3: ASPA - Assign an access code to UNIFORM CALL DISTRIBUTION [U-1], SRV = SSCA (Service
Code Appendix), SIDA = 50 Busy Set, SRV = SSCA (Service Code Appendix), SIDA = 51 Busy
Cancel. Connection Status CI = N, Normal (N).
STEP 4: AUOG/AUOGL - Assign the UCD OVERFLOW data via this command. Assign the following:
TN-A, STN-A/UGN-A, TELN-A: Tenant Number and Station Number/User Group Number and
Telephone Number that belong to a UCD group.
TN-B, STN-B/UGN-B, TELN-B: Tenant Number and Station Number/User Group Number and
Telephone Number of a member station in a UCD group to be
hunted in the case where the UCD group designated by TN-A and
STN-A happens to be busy.
TRANSLATION: When UCD Group A is busy, calls will overflow to UCD Group B.
STEP 5: AKYD - To a programmable line/feature key on the UCD stations (when the stations are D
term
s),
assign FKY = 19-UCD Busy Out.
STEP 6: ADSL - Assign UCDBO key; Assign SN=0 (Idle), 3 (Called Station Busy) and FKY=19 (UCD Busy
Out).
This command is required for assigning a function to each soft key.
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note
STEP 1: ASYDN - This data must be assigned to the NCN. System Data 1, Index 60, b3: 0/1 = UCD Queuing
is used/not used
STEP 2: AUOGN - This data must be assigned to the NCN. Assign the UCD OVERFLOW data via this
command.
UGN-A: User Group Number belonging to a UCD group
TELN-A: Telephone Number belonging to a UCD group
UGN-B: User Group Number of Overflow Destination
TELN-B: Telephone Number of Overflow Destination
Note: When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.